ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION [SKYACTIV-G 2.0]

Voltage Inspection

NOTE:

• The APP sensor is built into the accelerator pedal. When replacing the APP sensor, replace the accelerator pedal.

1. Connect the M-MDS to the DLC–2.

2. Switch the ignition ON (engine off).

3. Verify that the APP sensor output voltage (PID: APP1, APP2) increases according to the increase in the accelerator opening angle when the accelerator opening angle is gradually increased. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)].)

• If verified, go to the next step.

• If not as verified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

4. Verify that the APP sensor output voltage (PID: APP1, APP2) is within the specification when the accelerator pedal is depressed and not depressed. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)].) (See PCM INSPECTION [SKYACTIV-G 2.0].)

• If not as specified, replace the accelerator pedal. (See ACCELERATOR PEDAL REMOVAL/INSTALLATION [SKYACTIV-G 2.0].)

Specification (Reference)