< Previous
Next >
DRIVE SELECTION SWITCH REMOVAL/INSTALLATION [SKYACTIV-G 2.0]
1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION.)
2. Remove the selector lever knob. (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION.)
3. Remove the shift panel component. (See SHIFT PANEL REMOVAL/INSTALLATION.)
4. Remove the upper panel. (See UPPER PANEL REMOVAL/INSTALLATION.)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
1 |
Screw |
2 |
Drive selection switch |
Drive Selection Switch Installation Note
1. Install the drive selection switch so that the arrow shown in the figure is pointed toward the vehicle front.< Previous Next >